b. Place door and overlay on a clean flat protective surface. Use
the door frame holes as a guide to lightly punch pilot holes for
the #6 x 1" pan-head screws (see Figure 6).
c. Attach the door to the overlay using the #6 x 1" wood screws.
(Model 2075 shown.)
NOTE: The door frame is designed with a slight amount of “play”
to square the frame to the overlay panel.
d. Remove all traces of tape securing panel to frame.
ASSEMBLING THE DOOR
Starting at the corners and working toward the center, push the
door gasket back into place. Make sure gasket is fully seated on
all four sides.
FIGURES 7-8 – INSTALLING THE DOOR
Figure 7
PIVOT POST
TOP PIVOT PLATE
FLUSH MOUNT SCREWS
IN BRACKET SO YOU CAN
SEE THE HEAD ONLY
7
If you decide to drill the pilot holes, remove the door
and do not use a drill bit larger than 7/64", and do not
drill deeper than 3/8". Frame and door overlay must be
aligned properly or the door will not operate correctly.
