www.U-LineService.com
8
07/2006
1115R and 1115WC Models
Side-By-Side Installation
Instructions
For a complete refreshment center, install two of the
1115 series units side by side: 1115R and 1115WC.
• Cut-out width for a side-by-side installation is the total
of the widths listed under
Cut-Out Dimensions
in each
unit’s Installation Guide.
For example:
Placing a 1115R next to a 1115WC would require a cut-
out width of:
15-3/16" + 15-3/16" = 30-3/8"
• No trim kit is required. However, 1/4-inch space needs to
be maintained between the units to ensure
unobstructed door swing.
• Units must operate from separate, properly grounded
electrical receptacles placed according to each unit’s
Electrical Specifications
.
Three types of custom treatments may be involved in your
installation:
• 1115R Refrigerators will accept a custom 1/4" thick
insert to harmonize with or accent the surrounding
decor.
• 1115WC are equipped with maple-trimmed wine racks
that are coated at the factory with a clear vinyl sealer,
which will adequately protect the wood in normal
usage. A final finish coat was not applied so that the
wood trim could be stained to match décor. The trim
on the racks may be coated with a final finish or
stained.
If none of these treatments are to be included in this
installation, go on to
5 Adjust Door
.
Custom 1/4'' Thick Door Panel Insert
(1115R Refrigerator Units Only)
Door Panel Preparation
A custom door panel can be inserted into the doorframe.
Custom door panels can be flat or raised, as long as the
maximum panel thickness where inserted into the door
reveal (channel) is 1/4"-thick. For raised panels, the depth
of the reveal is 1/4" on all four sides.
IMPORTANT
Raised panels will reduce the door’s 90° swing/zero
clearance if the unit is installed next to a wall or similar
type of structure.
Cut the panel insert to the following dimensions.
Custom 1/4" Dimensions
for
1175 Black & White units
:
Width:
22-15/16"
Height:
26-15/16"
Custom 1/4" Dimensions
for
1115 Black units
:
Width:
13-15/16"
Height:
26-15/16"
The door panel must not weigh more than 20 lbs.
Door Panel Installation
Install the insert as follows:
CAUTION
Use care when handling the insert. Insert edges may be
sharp.
1. Remove top hinge screw pin with Phillips head
screwdriver. Remove door by tilting forward and lifting
off bottom hinge pin.
1-1/2"
7"
34-1/8"
to
35"
1/4" Space
Between Appliances
23-1/8"
Figure 12
Typical Side-By-Side Cut-Out
4 Prepare/Install Door Panel or
Prepare Racks
