www.U-LineService.com
12
07/2006
1115R and 1115WC Models
Leveling Information
Note:
It is recommended that the unit is level.
1. Use a level to
check the levelness
of the unit from
front to back and
from side to side.
Level should be
placed along top
edge and side
edge as shown
(see
Figure 18
).
2. If the unit is not level, adjust the feet on the corners of
the unit as necessary (see
Figure 19
).
3. Check the levelness after each adjustment and repeat
the previous steps until the unit is level. Go on to
8 Install the Unit
.
Installation Tip
If the room floor is higher than the floor in the cut-out
opening, adjust the rear feet to achieve a total unit rear
height of 1/8" less than the opening’s rear height. Shorten
the unit height in the front by adjusting the front feet.
This allows the unit to be gently tipped into the opening.
Readjust the front feet to level the unit after it is correctly
positioned in the opening.
Installation of the 1115R/1115WC
1. Plug in the power cord.
2. Gently push the unit into position. Be careful not to
entangle the electrical cord.
3. Re-check the leveling, from front to back and side to
side. Make any necessary adjustments. The unit’s top
surface should be approximately 1/8" below the
countertop.
Glass Shelf Installation
(1115R Refrigerator Only)
1. Carefully remove the glass shelves from the packaging.
2. Slide the shelves onto
lower sets of ribs,
making sure the
decorative graphics are
on the underside of the
shelves. White edge
strips go toward the
rear and silver edge
strips go toward the
front. See
Figure 20
.
7 Level the Unit
ULIN_0041_A
1
Figure 18
Turn Foot to Adjust
Figure 19
8 Install the Unit
Figure 20
