LISA-C200 & FW75-C200
AT commands examples - Application Note
CDMA-CS-12000
Preliminary
Page 5 of 41
1
Introduction
This document provides examples of using AT commands with u-blox LISA-C200 and FW75-C200 CDMA 1xRTT
wireless modules. Refer to
u-blox LISA-C200 and FW75-C200 AT Commands Manual
[1] for the command
descriptions. The following symbols are used to highlight important information within the document:
An index finger points out key information pertaining to integration and performance.
A warning symbol indicates actions that could negatively impact or damage the module.
This document applies to the following products:
o
FW75-C200 series
o
LISA-C200 series
These icons will be used to indicate applicability to the related products:
: FW75-C200 series
: LISA-C200 series
If the subchapter applies to a specific product the related icon will be provided there.
2
Service provisioning
2.1
Service provisioning in Verizon networks
Some logistic preparation is required prior to activating a module on Verizon Networks, we recommend
that customers directly contact their Verizon Customer Representative to properly setup the wireless
accounts. Once the lines have been provisioned, proceed with the activation steps as noted below.
2.1.1
Module activation
Command
Response
Description
AT+CMEE=2
OK
Set verbose error messages
AT$MDN?
0000002423
OK
Review the actual MDN in the module, if the response
is similar to the example, then the module isn’t active
yet.
AT+CDV=*22899
NO CARRIER
+UACTIND: 0
OK
Starts the Over-The-Air activation process, use the
code *22899 for module activation, make sure it has
been provisioned by Verizon prior to this step,
otherwise it will be unsuccessful.
+UACTIND: 0 indicates a successful OTA provisioning
session.
If the response is +UACTIND: 1, the terminal is either
not activated or the OTA session failed.
AT$MDN?
8584726201
OK
Reviews the new MDN stored in the module
LISA-C
FW-75
LISA-C
FW-75
