u-blox EVK-R5, Руководство пользователя

Страница: 6 / 24

EVK-R5 - User guide
UBX-19042592 - R09 Starting up Page 6 of 24
C1-Public
The USB interface of the cellular module (available for diagnostic purpose only) is available on the
native USB connector (J105) mounted on the cellular adapter board.
Other SARA-R5 series peripherals are available on the dual-in-line male board-to-board connectors
(J103, and J104) and the 2-pins header connector (J107) provided on the top layer of the cellular
adapter board.
The lower board (EVB-WL3) is also designed to be used with other u-blox cellular adapter boards. It
contains additional switches, jumpers, connectors, LEDs and parts that may be only partially
described in
Figure 1 or in this document, because they are intended for use only with other u-blox
cellular modules. It is recommended to leave any additional connector unconnected and any additional
switch in its default configuration.
J248
Pin 1
J248
Pin 3
J107
Pin 1
Figure 3: 3-pin header J248 available to set the routing of the UART interfaces on the EVK for SARA-R5 series modules
1.3 Switches, jumpers, and buttons
Function
Description
Name
Board
Main power switch Power on / off the whole evaluation kit SW400 EVB-WL3
Cellular VCC jumper Jumper socket to provide the 3.8 V supply to the cellular module VCC input J404 EVB-WL3
J109 ADP-R5
Cellular power on Push button to switch on / off the cellular module SW302 EVB-WL3
Cellular reset Push button to reset the cellular module SW303 EVB-WL3
Cellular UART detach Slide switch to attach / detach the cellular module main UART from the
USB / RS232 connectors on EVB-WL3 SW401 EVB-WL3
Cellular UART routing
Slide switch to select cellular module main UART routing on the USB or
RS232 connector on EVB-WL3
SW403 EVB-WL3
Cellular UART routing 3-pin header to route and make accessible the UART(s) of SARA-R5 series
over the USB connector on the ADP board, or over the USB or RS232
connectors on the EVB-WL3, or over the DIL B2B connector on the ADP board J248 ADP-R5
Cellular GPIO detach Slide switch to attach / detach the cellular module GPIOs from peripherals:
when detached, the signals are available only on the DIL B2B connector on the
ADP board SW300 EVB-WL3
Cellular GNSS detach 2 Slide switch to attach / detach the cellular module to / from the GNSS module
(GPIO2-3-4): when detached, the signals are available only on the DIL B2B
connector on the ADP board
SW304 EVB-WL3
GNSS V_BCKP Slide switch to connect / disconnect backup battery to / from the V_BCKP pin
of the GNSS module SW204 EVB-WL3
Table 1: EVK-R5 switch and button descriptions
2 For EVK- R510M8S it is recommended to keep this switch in “detach” position.