2
3
EN
G
L
ISH
EN
G
L
ISH
INSTRUCTION MANUAL
JUG KETTLE
SAVE THESE INSTRUCTIONS!
PRODUCT DESCRIPTION
1. Hinged Lid
2. ON/OFF Switch
3. Pilot Light
4. MAX Water Level Indicator
5. Cordless Power Base
6. 360° Connector
IMPORTANT SAFEGUARDS
When using your kettle, basic safety precautions should always be followed, including the
following:
1. Read all instructions carefully, even if you are familiar with the appliance.
2. Close supervision is necessary when any appliance is used by or near children.
3. Before connecting the kettle, check if the voltage indicated on the appliance corresponds with
the mains voltage in your home. If this is not the case, contact your dealer and do not use the
kettle.
4. Switch off and unplug from the outlet before illing, emptying or cleaning, or when not in use.
5. Do not overill as boiling water may be ejected. The maximum level is marked inside the
kettle.
6. Do not operate or place any part of this appliance on or near any hot surface (such as gas or
electric burner or in a heated oven).
7. Do not let the cord hang over the edge of a table or counter. Do not let the cord touch hot
surfaces.
8. Never yank on the cord as this may damage the cord and eventually cause a risk of electric
shock.
9. If the supply cord of this appliance is damaged, it must only be replaced by a repair shop
appointed by the manufacturer, because special purpose tools are required.
10. Avoid touching hot kettle surfaces - use the handle and the knobs.
11. To avoid possible steam damage, turn the spout away from walls or cabinets when operating
the kettle.
12. If operated on wood furniture, use a protective pad to prevent damage to delicate inishes.
13. To avoid scalding, always ensure the lid is correctly positioned before operating.
14. Scalding may occur if the lid is removed whilst heating.
15. Extreme caution must be used when moving the kettle containing hot water. Never lift the
kettle by it’s lid. Always use the body handle.
16. Do not switch your kettle on if it is empty.
17. To protect from electrical hazard, do not immerse this kettle or cordset in any liquid.
18. Use the kettle only with the supplied base unit. Do not use the base unit for other purposes.
19. To protect against ire, do not operate in the presence of explosive and/or lammable fumes.
20. A kettle should not be left connected to a wall socket when the room temperature is likely
to fall to outdoor winter temperatures. At sub-zero temperatures the automatic control
thermostat may reset to boil and energize the element.
21. Do not use the kettle for any purpose other than heating water. Other liquids or food will
contaminate the interior.
22. This product has not been designed for any other uses than those speciied in this manual.
23. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
24. Children should be supervised to ensure that they do not play with the appliance.
WARNING:
Compare the local voltage with the voltage declared on the device.
INSTRUCTIONS FOR USE
1. Before irst use, ill the kettle with clean water to maximum capacity and boil. Discard the
water and repeat.
2. The kettle should always be unplugged when illing or adding water.
3. Fill the kettle with water to the desired level. Do not overill or there will be a risk of spillage
or spitting. Do not forget to close the lid after illing, otherwise the kettle will not automatically
switch off after use.
4. Do not ill with less than 0.5 litre of water (up to „MIN“ indication) to prevent the kettle runnning
dry while operating.
5. Do not ill with more than 1.8 litres of water (up to „MAX“ indication).
6. An automatic safety cut-out has been itted for protection against overheat ing. It will operate
if the kettle is switched on when containing insuficient water. Always ensure that the water
inside the kettle covers the minimum mark. If the automatic safety cut-out has operated,
disconnect from the power outlet and allow the kettle to cool down for 5 to 10 minutes. Then
reill with water and switch on - the kettle will then boil and cut off as in normal operation.
7. Place the power base on a dry lat surface.
8. Place the kettle on the power base. The electrical connections will be made automatically as
the kettle slides onto the power base.
9. Plug the cordset into an earthed power socket.
10. The appliance is switched on by pressing the ON/OFF switch. The pilot light will come on
11. When the water has boiled, the kettle will switch off automatically.
12. Do not remove the kettle from the power base without switching off irst.
13. To pour water, lift the kettle from the power base and pour.
HOW TO CARE FOR YOUR KETTLE
Wipe the exterior of the kettle with a soft, damp cloth or sponge. Remove stubborn spots with a
cloth moistened with mild liquid detergent. Do not use abrasive scouring pads or powders. Never
immerse the kettle in water or other liquids.
From time to time depending on the nature of your water supply, a lime scale deposit is naturally
formed and can be found mostly adhered to the heating element and reduces the heating
capacity. The amount of lime scale deposited (and subsequently the need to clean or descale)
largely depends on the water hardness in your area and the frequency with which the kettle is
used.
Limescale is not harmful to your health. But if poured into your beverage, it can give a powdery
taste to your drink. Therefore, the kettle should be descaled periodically as indicated below:
DESCALING
Descale the kettle regularly. With normal use, at least twice a year.
1. Fill the kettle up to „MAX“ with a mixture of one part ordinary vinegar and two parts water.
Switch on and wait for the appliance to switch off automatically.
2. Let the mixture remain inside the kettle overnight.
3. Throw the mixture away next morning.
2
6
5
4
3
1
