6
Acceptance and transportation
EN Floor grinding machine FGE 530
12
6
Acceptance and transportation
Follow the safety instructions in Chapter 2.
6.1 Machine acceptance
The packaged machine is supplied complete from the
manufacturer.
1.
Unpack machine and check the delivery slip to
make sure all parts are delivered.
2.
Check for any transportation damage.
3.
In case of damage, contact the transport com
pany promptly.
4.
Report any problems to the manufacturer imme
diately.
Complaints at a later date cannot be acknowled
ged!
6.2 Transporting the machine
Risk of injury from heavy parts!
Suspended loads can fall or tip over, causing
serious injuries!
Do not stand under suspended loads!
Raising and lowering the load must be perfor
med by two persons!
Do not raise loads any higher than necessary!
Prevent the load from swinging back and forth!
Keep sufficient safety distance.
Devices for stopping and transporting the unit
have to be rated to handle its full weight and
dimensions.
Observe weight data on packaging or in the ac
companying documentation.
Never walk or reach beneath the load while it is
being lowered.
Wear safety shoes!
Wear safety gloves!
Proceed with the greatest care and caution!
For longer transports or longer storage, the ma
chine needs to be covered to protect against
soiling.
For transporting, the machine can be taken apart into
2 pieces. A relocation over shorter distances is possi
ble on the transport wheels.
1.
Decommission the machine (
!
Chapter 4.7)
2.
Either
a.
Fasten all loose parts to the frame.
b.
Move the machine to the respective loca
tion with the transport wheels [6, Fig. A]
and deposit.
or
a.
Unplug the plug connection [35, Fig. J],
Hose connection [23, Fig. K] and if neces
sary connection to the dust extrac
tion [24, Fig. K].
b.
Loosen the 4 screws [36, Fig. L] as far as
possible without removing, so that the bolts
[37, Fig. M] are movable.
c.
Push the bolts into the open position [Fig. M].
d.
Disconnect drive from the frame.
e.
If necessary (e.g. for lorry transport), screw
the 4 screws [36, Fig. L] tightly and fasted
all loose parts on the frame.
f.
Move drive and frame to the respective lo
cation and deposit.
g.
If necessary, lift drive and frame onto a sui
table transport device (e.g. a palette). If
necessary, use suitable lashing gear (belts
or ropes).
Always secure the machine according to regula
tions during lifting or transport by a vehicle or
suitable devices and strap down with tension
belts.
