Rear
(Fig 11) Passenger/right side of Bumper attached to
the
M
ounting Bracket illustrated
6/7
Customer Support: www.TygerAuto.com/Contact
STEP 10
With assistance, hold the Bumper assembly up to the ends of
the frame. Temporarily support the weight of the Bumper.
WARNING: To avoid possible injury or damage to the vehicle, do
not proceed until the bumper is fully and safely supported. Use
the provided (4) 10mm Flat Washers and (4) 10mm Nylon Lock
Nuts to attach the Bumper to the Mounting Brackets, (Figures
11).
NOTE: On models with HD tow package with integrated receiver
hitch the Bumper will attach directly to the integrated hitch,
(Figure 12). Snug but do not fully tighten hardware at this time.
(2) 10mm Flat Washers
(2) 10mm Nylon Lock Nuts
STEP 11
Level and adjust the bumper and fully tighten all hardware.
STEP 12
Reinstall the license plate lights, spare tire access lock and
trailer plug to the front of the Bumper, (Figure 13).
(Fig 12) Passenger/right side of Bumper attached
directly to the integrated hitch illustrated
Rear
(2) 10mm Flat Washers
(2) 10mm Nylon Lock Nuts
WARNING
!
Do not crawl under bumper unless the bumper is
properly supported on blocks or stands or the bumper may fall.
(Fig 13) Attach trailer plug, spare tire access lock,
license lights and plate to the front of the Bumper
Rear
(2) Plastic Plugs
Attach the wiring harness to the lights and trailer plug. Use
the included Wire Ties to secure the wiring harness to the bumper
and frame as necessary.
STEP 13
STEP 14
Use the included (2) push-in plugs to attach the license plate to
the Bumper, (Figure 13).
