4/7
Customer Support: www.TygerAuto.com/Contact
.
As per winch instructions, never wind rope over top of the winch drum.
Foam Spacer
(Fig 6) Sensor assembly pictured from back
of bumper
Foam Washer
Retaining
C
lip
STEP 5
Sensors, (if equipped), must be installed onto the back of the Bumper
before attaching the Bumper to the vehicle.
Models wihtout bumper sensors:
a. Select the included (4) Rubber Plugs.
b. From behind bumper, push plugs into sensor mounting holes.
Models with bumper mounted sensors:
a. Remove the small factory sealing washer from the sensor. Attach
the provided larger (1) Foam Washer onto the front of the sensor,
(Figure 6).
b. Slide the sensor into the sensor sleeve opening on the back of the
Bumper. Attach (1) Foam Spacer to (1) Retaining Clip. Push and lock
the Retaining Clip into the sensor sleeve mounting holes, (Figure 6).
c. Repeat the previous steps to install each sensor to the back of the
Bumper.
STEP 6
Use a small flat blade screwdriver to pry the star washers off of the
bolt plates used to attach the factory bumper to the frame,
(Figure 7). NOTE: “HD” tow package models use a triple bolt
plate, “Standard” and “Max Duty” equipped models use a
double bolt plate.
(Fig 7) Use flat blade screwdriver to pry off
lock washers from bolt plates
NOTE:
