H o w to Install the Unit
H o w to Install the Unit
How
to
In
st
al
lt
he
U
ni
t
How
to
In
st
al
lt
he
U
ni
t
H
ow to Install the Unit
Determine if you will connect unit directly to cold water supply line (under-sink) or to
faucet (see image)
Option A
l
Faucet:
Faucet connection requires faucet diverter (included) or
Option B
l
Under-Sink:
under-sink connection requires under-sink adapter kit
(not included) or compatible t-valve (available from most hardware stores)
Option A
– Faucet Installation
Many faucets vary in design, and your faucet may require different setup instruc-
tions than those featured in this manual. Please consult a qualified service profes-
sional if you are unable to correctly complete the installation. For more help with instal-
lation, please visit
1. Shut off both hot and cold water main supply at pipe under-the sink.
2. If your faucet features a screw-on style aerator, remove it by unscrewing it from
the tip of the faucet.
3. If the included faucet diverter does not fit directly to the tip of the faucet, select an
appropriate size connector and rubber washer (included).
4. When connecting diverter or adapter to faucet, be sure to use plumbing pipe thread
seal tape (not included) to prevent leaks.
5. Connect faucet diverter or faucet diverter (with appropriate connector) to faucet.
6. Be sure all connections are secure but do not over tighten.
1. Purchase either an under-sink installation kit (not included) or purchase T-
connection (with shut-off valve) from a hardware or plumbing supply store.
2. Shut off both hot and cold water main supply at pipe under-the sink.
3. Locate the cold water supply line valve.
4. Disconnect faucet cold water supply line from main cold water pipe
– usetowel
to catch small amount of water that may come from faucet supply line.
5. When connecting T-connection to cold water pipe, be sure to use plumbing
pipe thread seal tape (not included) to prevent leaks.
6. Reconnect faucet cold water supply line to T-connection (now secured to main
cold water pipe)
7. Be sure all connections are secure but do not over tighten.
Option B
– Under-Sink Installation
Both Options
Do not turn on main water supply until all hoses are properly installed to the unit.
Unit and components are subject to change without prior notification in order to
enhance performance.
16
17
