12
BTEL-3G
Delete
To delete a programmed phone number, type the following keypad sequence:
5
c
<Position no.>
where <
Position no.
> is a number from
1
to
9
. If, for example, if you want to delete the third programmed telephone
number (position no. 3), type
5
c
3
.
Superkeys
Ë
Ë
Ë
Ë
Ë
The BTEL-3G has two SUPERKEYS (the
1
key and the
2
key), which, when pressed for at least 3 seconds,
perform specific actions:
—
When you press
1
, a call is made to the telephone number stored at position 9 in the phone book and the
speakerphone function is enabled. After 5 minutes and after that at 30-second intervals, a tone is sounded on the audio
channel. To end the call, press or wait for the other party to hang up.
—
When you press
2
, a call is made to the telephone number stored at position 9 in the phone book and voice message
no. 7 is played five times. If the call result is not successful (no answer, busy, or unreachable), the device automatically
attempts to call again 5 times (after 1, 2, 5, and 10 minutes). Repeated call attempts can be ended by the Block Calls option
(see the "
Block Calls
" section) or by activating Input no. 4 (L4).
I
I
I
I
I
The SUPERKEY
1
function cannot be enabled if other calls are in progress.
During calls made with Superkeys
1
and
2
the other party can access the User Menu remotely by pressing
#
.
Remote Programming by text message
By sending specific text messages, you can manage some features of the BTEL-3G. For the features, see the paragraphs
below.
Output Management
Open Collector outputs OC1, OC2, and OC3 can be set as
Bistable
(enabled and disabled with 2 different commands) or as
Monostable
(the output is active for its
ON Time
, after which it returns to standby). Output OC4 is set as
Bistable
.
I
I
I
I
I
If the output is enabled by sending a text message,
Confirm Output Activation Enable
(if programmed by
the installer) will be sent by text message.
Bistable Output
Open Collector outputs set as
Bistable
can be enabled or disabled by sending a text message with the following format
(use capital letters):
#
User PIN
#
Output#
ON#
(example: #
85649
#
OC1
#
ON
#)
#
User PIN
#
Output#
OFF
# (example: #
85649
#
OC1
#
OFF
#)
where the following are enclosed by # signs :
User PIN
is a numeric code of 5 digits (from 00000 to 99999);
Output
is the Open
Collector Output (OC1, OC2, and OC3);
ON
enables the output;
OFF
disables the output.
I
I
I
I
I
The factory default
User PIN
is "00000". To change it, see the Section "
User->Change Code
".
