801AP
17A-05-AP
4
8/07
© 2007 Tyco Safety Products
PAGE 3 of 10
EQUIPMENT:
PUBLICATION:
ISSUE No.
&
DATE:
The Service Tool requires a 6-digit password to be entered.
The password is different for each service tool and will be
issued by the respective branch office.
The password uses only the digits 1 to 4, and may be entered
by pressing the corresponding buttons F1 to F4; eg, button F1
to enter 1, button F2 to enter 2, etc.
The user has 3 attempts to enter the correct code. On the 4th
attempt the following screen is displayed:
The user must telephone the branch office to get the correct
6-digit password at this point.
WARNING:
FAILURE TO ENTER THE CORRECT
PASSWORD AT THE FOURTH ATTEMPT
WILL RESULT IN THE SERVICE TOOL
SWITCHING OFF AND ALLOWING ONLY ONE
ATTEMPT ON SUBSEQUENT POWERING UP
OF THE UNIT.
The password has an expiry time associated with it.
The hours left indicates the actual usage (switched on) time
remaining.
CAUTION:
ONCE THE HOURS LEFT REACHES ZERO,
THE SERVICE TOOL BECOMES
INOPERABLE AND MUST BE RETURNED TO
THE BRANCH OFFICE.
When there is less than 50 hours, the expiry time appears. The
screen displays the expiry time in the form of ‘Hours Left’:
On successful entry of the password, the following screen is
displayed:
This is the start of the main menu options, which are
discussed further in para. 3.5.
Phone Base
Password:
Hours Left: 46
Password:
(example)
<-- Select -->
ADDRESS PROGRAM
3.3
CONNECTING TO A DEVICE
Detectors are inserted as shown in Fig. 3. Use the marking on
the service tool (above F1 button) to align the detector. Place
detector in position 1 to engage and then twist clockwise to
position 2 to lock.
Ancillaries are connected to the ‘AUX’ socket using the
ancillary connection lead connector lead as shown in Fig. 4.
Note:
1) It is good practice to connect only a detector or
ancillary at any one time. However, the Service
Tool is equipped with a port interlock feature.
When the ancillary lead is connected to the ‘Aux’
socket, communication with the detector will be
disabled. When the ancillary lead is removed,
the detector will be able to communicate.
Fig. 3
Connecting a detector
POSITION 2
POSITION 1
MARKING
Fig. 4
Connecting to an ancillary
www.acornfiresecurity.com
www.acornfiresecurity.com
