16
17
5
Printing Operation
!
Attention!
Printhead damage caused by improper handling!
Do not touch the underside of the printhead with the fingers or sharp objects.
Ensure that the labels are clean.
Ensure that the label surfaces are smooth. Rough labels act like emery paper and reduce the service life
of the printhead.
Print with the lowest possible printhead temperature.
The printer is ready for operation when all connections have been made and labels and, if applicable, the transfer
ribbon have been loaded.
Calibration of the Paper Feed
After the label stock has been inserted, for cutting mode a calibration of the paper feed is required. That way the
first label, which is detected by the label sensor, will be transported to the print position and all labels in front will be
fed out of the printer. So the calibration avoids, that the first cut label would be too long. That can cause useless first
label.
Press the
feed
key to start the calibration.
Remove the blank labels cut during the calibration.
i
Notice!
Calibration is not necessary if the printhead was not opened between different print jobs, even if the printer
was switched off.
