3
Control Unit
SECTION 1 GENERAL DESCRIPTION
Heat Gun
The CE 240-Vac AA-400 Mark IV
super heater is a compressed-air
heating tool—
one that offers precise control of the
heated air stream, especially in
confined areas. It operates with a
mains voltage of 240 Vac.
The AA-400 Mark IV performs
equally well in production, rework, and
prototype applications. Five different
reflector tips are available, providing a
wide range of air-flow patterns and
temperatures.
The needle-point tip is used for micro-
miniature connectors. This tip comes
standard with the AA-400 Mark IV.
The Mini SolderSleeve reflector tip is
used for installing SolderTact contacts
and SolderSleeve terminations in
confined areas. This tip comes standard
with the AA-400 Mark IV.
The low-flow-point tip is used for
installing small heat-shrinkable parts,
such as micro tubing and boots. This
tip must be ordered separately.
The SolderSleeve Reflector tip is used
for installing SolderSleeve shield
terminators and wire splice sleeves.
This tip must be ordered separately.
The boot and tubing reflector tip is
used for shrinking large-diameter
Thermofit tubing products and molded
heat-shrinkable components. This tip
must be ordered separately.
General Warning
Electrical Warning
Read Warning
Hot Surface
As with all electrical equipment, the
AA-400 Mark IV must be operated
properly. Carefully read and observe
all of the instructions and warnings in
this manual.
Incorrect use of the AA-400 Mark IV
can cause serious injury. This
equipment must be operated and
maintained only by fully trained and
qualified personnel.
Failure to follow the manufacturer’s
instructions may void the warranty of
this equipment.
The AA-400 Mark IV must be
operated in accordance with safe
working practices and local safety
codes and regulations.
SECTION 2 SAFETY
General
The control unit contains several
features:
• Mains power double-fused chassis
plug.
• Two-meter removable power cord.
• Pressure regulator and gauge for
adjusting air flow and temperature.
•
Green HEAT ON indicator LED that
illuminates when power is applied to
the heating element.
• Automatic power cutoff switch to
protect the heating element if the air
flow is interrupted or turned down
below a safe operating pressure.
•
A three-pin mains inlet connector
with
two single-pole screwdriver-
release fuse
cartridges to accept
five 20-mm fuses.
• A pressure-relief valve.
Do not use the AA-400 Mark IV for
any purpose other than its intended
function.
The AA-400 Mark IV carries an
International Protection (IP) Code of
IP30 for the control unit and IP20 for
the heat gun assembly. Never expose
the
AA-400 Mark IV to rain or moisture.
Labels and Warning Symbols
This tool carries a label (shown below)
that displays the product part number
(PCN), product description, electrical
rating information, air pressure infor-
mation, and wiring schematic drawing
number.
Warning symbols appear at right.
Raychem Interconnect a division of Tyco Electronics International Ltd. Printed in USA No.: TUS-44-3300 Revision: None
Revision Date: February 16, 2000 Page: 3 of 8
Содержание Raychem Interconnect AA-400 Mark IV
Страница 1: ......
