24 Port Ethernet Switch With Optional Fiber Port
Tyco Electronics
Page 3
Front Panel
The front panel of the switch has 24 x RJ-45 Shielded/Unshielded
Ethernet Ports, an optional fiber Ethernet 100Base-FX uplink port,
a console management port and an array of LED indicators.
Figure 1 – Switch with optional fiber module (SC Connector) fitted
Ports
Figure 1 - Switch with optional fiber module fitted
RJ-45 Ports.
These Ethernet RJ-45 ports support both
shielded and unshielded cabling systems. The port auto-
negotiates the 10/100Mbit/s network speed or can be
forced by the console management interface into either
10Mbit/s or 100Mbit/s at either full-duplex or half-duplex.
Each port supports Auto-MDI/MDI-X which allows either
straight through or cross-over cables to be used.
100FX Fiber Port.
This optional, field installable plug-in
module provides the fiber link to the distant media
converter, NIC card or Ethernet switch. The port operates
in either full duplex or half duplex modes depending on the
setting of DIP switch on the panel of the plug-in module.
Modules with SC, ST and MT-RJ fiber optic connectors are
available. See page 6 for order codes.
Console Port.
A PC or other RS232 terminal is connected
to this port to enable detailed management of the switch.
See the documentation on the web site for full information.
Rear Panel
The rear panel contains the 110/240v AC 50/60Hz power socket
and power switch. Note that the fusing is external to the switch. To
disconnect power, remove the plug.
