408-8908
SOLISTRAND Flag Terminal Crimping Dies
3 of 6
Rev O
Wire Barrel
Crimped
Flag Terminal
Die Set
Terminal
Strip Length
Hydraulic Head (Typical)
PRODUCT
NOMINAL WIRE SIZE
STRIP LENGTH
PRODUCT
MM
2
AWG
MINIMUM
MAXIMUM
696775-1
696779-1
7-8
8
9.53 [.375]
11.18 [.440]
322727-[ ]
321576
13-15
6
12.70 [.500]
14.27[.562]
321060
21
4
13.82 [.554]
15.48 [.609]
321064
34-35
2
17.06 [.672]
18.65 [.734]
321066
59-60
1/0
22.23 [.875]
23.81 [.937]
321584
67-70
2/0
23.81 [.937]
25.40 [1.000]
327887
80-95
3/0
26.98 [1.062]
28.58 [1.125]
321259-[ ]
100-125
4/0
28.58 [1.125]
30.16 [1.187]
Figure 3
Figure 4
Hydraulic Head (Typical)
Center Terminal
Wire Barrel in Nest
Hold Flag Terminal
Tongue Against
Slope on Nest Until
Crimp is Started
5. MAINTENANCE AND INSPECTION
Disconnect power supply before performing
maintenance, adjustments, inspections, and
repairs.
5.1. Crimp Inspection
(Figure 5)
Inspect crimped terminals by checking the features
described in Figure 5. Use only terminals that meet
the conditions shown in the ACCEPT column.
Terminals displaying the features shown in the
REJECT column can be avoided by careful use of
these instructions and by performing the maintenance
and inspection procedures described in Paragraphs
5.2 and 5.3.
5.2. Daily Maintenance
It is recommended that each operator of the dies be
made aware of, and responsible for, the following steps
of daily maintenance.
DANGER
