13
http://www.tyan.com
Memory Pair Installation
You must install the first two memory modules in DIMM B1
and DIMM A1
.
Both modules must be the same in both size and density. Modules must also use the same chip
configuration, as in each module that is installed must physically have the same number of
memory chips on them.
All memory sockets must be populated by the same memory type, either x4 modules or x8
modules. You cannot mix and match x4 and x8 modules together. The Thunder i7500 will not
support any other type of memory configuration.
A few things to remember:
•
At least TWO Registered DDR SDRAM module must be installed
for the system to turn on and POST (power on self test) and
DIMM modules must be installed in pairs.
•
Use ONLY x8 or x4 type memory modules. Mixing memory types
affects stability.
•
When installing modules, install them in this order: B1, A1, B2,
A2, etc.
•
128MB, 256MB, 512MB and 1GB Registered PC2100/PC1600 DDR
SDRAM memory modules are supported in x4 or x8
configuration.
•
The Thunder i7500 supports up to 12GB of memory
