11
http://www.tyan.com
2.5 – Clear CMOS (JP1)
2.6 – Onboard ATI
RAGE XL Graphics (JP31)
JP1
CMOS Reset
(OPEN)
(CLOSE)
Normal
(default)
Clear CMOS
You can reset the CMOS settings in case an
incorrect setting causes system instability or
you have forgotten your system/setup
password or have just flashed your BIOS by
using these jumpers.
•
Power off system and disconnect the AC
power from the power supply.
•
Set jumper JP1 to
Clear CMOS
.
•
Power system on and wait for the screen
to show this message: “CMOS Settings
Wrong, CMOS Checksum Bad”. Now the
CMOS is cleared.
•
Power off system and disconnect the AC
power from the power supply and set
jumper JP1 to
Normal
(OPEN) for normal
operations.
•
Power system on and go to BIOS Setup.
Load and save setup defaults.
JP31
Onboard ATI
RAGE XL Graphics
(OPEN)
(CLOSE)
Enabled
(Default)
Disabled
OPEN:
The jumper
enables
the onboard ATI
RAGE XL graphics controller. You can also use
the onboard video in conjunction with another
PCI graphics card for multiple monitor support.
CLOSE:
The jumper
disables
the onboard ATI
RAGE XL graphics controller.
