12
http://www.tyan.com
(JP10) (PCI-X Slot#2 at PCI Bus 2, for slot located next to the 32-bit PCI)
Open
the jumper to set slots to PCI-X mode.
(This is the default setting for
S2707GN
)
Close
the jumper to set the slots to PCI mode.
(This is the default setting for
S2707UGN
, if onboard AIC -7892x is present.)
Note:
§
No PCI-X 133/100 MHz jumper for Bus #2
Because this slot shares PCI Bus #2 with onboard 82545EM GbE and SCSI, the
Bus #2 has more than one device loads and cannot support PCI-X 133 MHz by
PCI-X specifications. Hence, there is no PCI-X 133MHz support for Bus #2.
§
PCI-X/PCI Mode on Bus #2
The onboard AIC-7892x Ultra160 SCSI controller cannot support PCI-X mode,
JP10 should be set to CLOSE in this case. However, because the optional
AIC-7901 Ultra320 SCSI can support PCI-X model, JP10 can be set to OPEN for
S2707GN
(non-SCSI) or with optional AIC-7901.
2.7 – Onboard LAN - Intel 82545EM Gigabit NIC (JP22)
Enabled
(default)
Open
the jumper(s) to enable the
Onboard Intel 82545EM Gigabit
Ethernet chip.
Disabled
CLOSE
the jumper(s) to disable the Onboard Intel 82545EM Gigabit
Ethernet chip.
