TYAN B5630G86CV12, Руководство сервисного инженера, Страница: 9 / 162

http://www.tyan.com
9
·
Make sure the rack is level and stable before installing an appliance in the
rack.
·
Make sure the leveling jacks are extended to the floor.
·
Make sure the full weight of the rack rests on the leveling jacks.
·
Always load the rack from the bottom up. Load the heaviest component in
the rack first.
·
Make sure the rack is level and stable before pulling a component out of the
rack.
·
Make sure only one component is extended at a time. A rack might become
unstable if more than one component is extended.
To avoid damage to the equipment:
·
The rack width and depth must allow for proper serviceability and cable
management.
·
Ensure that there is adequate airflow in the rack. Improper installation or
restricted airflow can damage the equipment.
·
The rack cannot have solid or restricted airflow doors. You must use a mesh
door on the front and back of the rack or remove the doors to ensure adequate
air flow to the system.
·
If you install the Model in a rack, do not place equipment on top of the unit. It
will cause restricted airflow and might cause damage to the equipment.
·
Make sure the product is properly matted with the rails. Products that are
improperly matted with the rails might be unstable.
·
Verify that the AC power supply branch circuit that provides power to the rack is
not overloaded. This will reduce the risk of personal injury, fire, or damage to the
equipment. The total rack load should not exceed 80 percent of the branch circuit
rating. Consult the electrical authority having jurisdiction over your facility wiring
and installation requirements.
·
Verify that the AC power supply branch circuit that provides power to the rack is
not overloaded. This will reduce the risk of personal injury, fire, or damage to the
equipment. The total rack load should not exceed 80 percent of the branch circuit
rating. Consult the electrical authority having jurisdiction over your facility wiring
and installation requirements.
·
Verify that the AC power supply branch circuit that provides power to the rack is
not overloaded. This will reduce the risk of personal injury, fire, or damage to the
equipment. The total rack load should not exceed 80 percent of the branch circuit
rating. Consult the electrical authority having jurisdiction over your facility wiring
and installation requirements.