Twose TS466, Руководство по эксплуатации

Страница: 28 / 54

19
DANGER VERY IMPORTANT
It is very important that motor spool and motor spool control lever works in one
direction only - From centre (OFF) position to selected (ON) 'rotor cut' direction
position – permitting the rotor one direction of cut and the 'OFF' setting only. This
eliminates the chance of going from ‘cut-up’ to ‘cut-down’ in one movement of
controls and blowing the system. Only by altering LOCK-LEVER setting can
direction of control lever be changed.
WARNING
DANGER - NEVER CHANGE DIRECTION OF ROTOR CUT WHILST
ROTOR IS STILL TURNING.
DANGER - ALWAYS ALLOW ROTOR TO STOP SPINNING
COMPLETELY BEFORE CHANGING CUT ROTATION DIRECTION.
On despatch from the manufacturer the machine will be supplied set as standard for
‘upward' rotor cutting unless specifically requested otherwise.
ROTOR CUT DIRECTION MUST NEVER BE CHANGED IN ONE MOVEMENT
The controller lever head for motor spool control is designed with a "LOCK-ARM
LEVER" which is operated by rotating and positioning as follows: -
Uphill Cutting
Lever positioned with long end of pin rearwards
- 9.00 o’clock when viewed from the side -
Control lever will now only be permitted to
travel in the neutral to the uphill cutting mode
(Off and Towards).
Refer to diagram opposite.
Downhill Cutting
Lever positioned with long end of pin forwards
- 3.00 o’clock when viewed from the side -
Control lever will now only be permitted to
travel in the neutral to the downhill cutting
mode (Off and Away).
Refer to diagram opposite.
WARNING:
Ensure rotor is stationary before switching
from one cutting mode to another.