Now, run the audio system harness along the bike wiring
on the frame. You will need to feed the harness through
the rubber wiring tunnel. To do this, straighten a coat
hanger and push it (n) though the wiring tunnel all the way
from the rear to the front(o) of the tank. At the rear of
the tank tape the wiring harness to the hanger using
electrical tape(p). Use extra tape to cover the front of the
harness plug, this will help smooth the feeding progress.
INSTALLATION · ELECTRICAL HARNESS
6
Use the hanger to pull the harness from the front end
of the gas tank, until the taped plug is through the
tunnel(q). Un-tape the harness from the hanger then
remove the hanger.
Feed the harness up the handlebar (r) to the audio system
and zip-tie the harness to the existing bike wiring using
Put the gas tank back in place and tighten the hardware that attaches the tank.
2 or 3 ties in front(s) of the tank and behind the tank(t).
n
o
q
p
r
s
t
