Fig. 12
REMOTE CONTROL FUNCTIONS
E-7
REMOTE CONTROL FEATURES WORK SEAMLESSLY WITH CONTROL PANEL FUNCTIONS
5 BUTTONS REMOTE
Models : 35HF500GRA -ESP /BLK/ OAK
POWER
HEATER
FLAME
NOTE: PLEASE OPERATE REMOTE TRANSMITTER AT A SLOW
MEASURED PACE. PRESS THE REMOTE CONTROL BUTTONS
WITH AN EVEN MOTION AND GENTLE PRESSURE. REPEATEDLY
PRESSING BUTTONS IN RAPID SUCCESSION MAY CAUSE THE
TRANSMITTER TO MALFUNCTION.
NOTE:
The fireplace Main Power Switch must be
switched ON in order for the Remote Control to function.
The Power button will put the fireplace in a standby
mode. This will turn off all functions at once but
will hold the settings in memory. Except Heater function,
by pressing the button again the unit will turn on at the
same settings.
The fireplace has four flame effects, by pressing the
FLAME button the unit will cycle through each effect.
NOTE: This remote control uses 1 CR2032 Lithium lon button cell battery (Included). Never dispose of
batteries in fire, except under conditions of controlled i
ncineration. (Failure to observe this precaution may
result in an explosion.)
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receive
r.
• Connect the equipment into an outlet on a circuit different f
rom that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for
help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Modifications not approved by the party responsible for compliance could void user’s authority to
operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003.
BACK LIGHT
The fireplace has five back light effects, by pressing the
backlight button the unit will cycle throught each effect
it including OFF setting.
SPEED
Press SPEED button, the flame speed will be changed.
Total 3 speed levels.
Press once turns left hand heater on. (Pilot lights
Press again turns left hand heater off and right hand
.heater on. (Pilot lights illuminated
○●)
Press third time turns left and right hand heater on. (Pilot lights illuminated
●●)
Press fourth time turns left and right hand heater off. (Pilot lights illuminated
○○
)
illuminated
●○)
Meijer.com
