Twin eagles Service (562) 263-3600 | 2
Read this instruction completely before starting installation.
Planning the complete installation before start-
ing work is highly recommended. This includes all aspects of the installation including hood location, ducting,
electrical requirements, and adequacy of mounting surfaces.
GETTING STARTED:
1. Remove all packaging materials, labels and protective plastic film. DO NOT LEAVE UNIT IN THE SUN WITH
PROTECTIVE PLASTIC FILM ON FOR AN EXTENDED PERIOD OF TIME AS IT WILL BECOME DIFFICULT TO RE-
MOVE.
2. Check to ensure all Vent Hood accessories listed below are included.
3. Assemble parts as per assembly instructions.
4. Fill out Warranty Registration Card and mail it to the indicated address, or register online. See page 17.
Vent Hood Accessories
TEVH36-C TEVH48-C TEVH60-C
BAFFLE FILTER
3
4
5
CAUTION:
•
To reduce the risk of fire and electric shock, install this vent hood only with Integral Blower TEVI-120I.
•
The hood is of sufficient weight that two installers are recommended to prevent injury or damage to the
hood in handling.
•
Hood is recommended for use over domestic gas or electric appliances.
Not recommended for use over
solid fuel fired appliances.
The vent hood is operated by a 3-speed rotary control switch located in the front left of the hood. Me-
dium to low speed will handle most exhaust requirements. Use the high-speed position for heavy cooktop use
conditions. Turn the vent hood on just before cooking to prevent the escape of discharges from the cooking
surface.
The light rotary switch is located to the right of the ventilation control.
OPERATING INSTRUCTIONS:
CLEANING AND MAINTENANCE:
CAUTION: Shut off power to unit at service entrance if you are cleaning the blower.
Use a damp cloth to wipe the outer surface of the blower. Do no use a dripping wet cloth to wipe blower. Nev-
er put your hand int the blower housing.
To clean the hood surface use only mild soap or detergent solutions. Wipe to dry surfaces using a soft cloth. If
a stainless surface is being cleaned,
always wipe in the direction of the brush surface
. Cleaning aids such as
“Stainless Steel Magic” are available. Never us abrasive cleaners, pads or cloth.