Twin Eagles TEBQ30G-B, Инструкция по установке, использованию и уходу

Страница: 22 / 32

USING THE GRILL
1. Check to be certain that the drip pan is in place and pushed all the way into the grill.
2. Light the grill burners using the instructions in use and care manual.
3. Turn the control knobs to HI and allow the grill to preheat for 15 minutes or until desired
temperature is displayed on the thermometer. The hood is to be closed during the appliance
preheat period.
4. Place the food on the grill and cook to the desired temperature doneness. Adjust heat setting, if
necessary. The control knob may be set to any position between HI and LO.
5. Allow grill to cool and clean the drip pan after each use.
Match/BBQ Lighter Lighting Instructions:
If there is no electrical power supply available or if hot surface igniter
will not light the burners, the burners can be lit manually using a
lighted long match, taper or BBQ lighter.
1.
Push and turn the knob counter-clock-wise to the biggest flame
marking on the bezel. Hold the knob pushed in for 5 seconds.
2.
Insert a lit match or BBQ lighter thru the hex grates and near
the top of the flashtube. Once you see or hear a flame you can
release the knob.
Important
: If burner fails to light within 5 seconds, turn off gas
and wait 5 minutes before repeating the process.
Warning
: If you smell gas, shutoff the gas supply and
immediately check for leaks using the soapy water technique.
INTERIOR LIGHT OPERATION
The
T
WIN
E
AGLES grill is equipped with two interior halogen lights and decorative knob LED lights for
late night grilling. The grill is equipped with a hood switch that allows the interior lights to shut-off
automatically when closing the hood.
1.
Push the switch located on the front panel to turn ON interior and knob lights.
WARNING: Do not touch the interior halogen lights. It may be hot and can cause serious burns.
REPLACING INTERIOR LIGHT BULBS
WARNING! Unplug the grill from the 120V power source before replacing the light bulb.
1. Gently pop the lens cover out.
2. Remove the old light bulb by pulling it straight out of the socket without twisting the light bulb.
Wearing plastic gloves, insert the new light bulb into the socket.
DO NOT touch bulb with bare
hands as the oil and dirt will shorten bulb life.
4. Gently push the lens cover back into the light assembly.
18