Technical changes for purposes of a technical advancement as well as deviation in colour, errors and printing mistakes are reserved.
9
Turn on the power switch
Press UP button
Motor drives the gear pump work
The lift is raised
Cylinder piston drives the platform move up
Press the DOWN button
The lift is lowered
Turn on the power switch
4.3 Flow chart for operation
4.4 Operation instructions
Raise the lift
1. Make sure that you have read and understood the operation manual before operation.
2. Drive and park the vehicle midway between two platforms.
3. Place the four rubber pads under the prop-points of the vehicle and ensure car’s gravity have fallen on the rubber pads.
4. Press the “UP” button on the control box until rubber pads have touched the prop-points of vehicle.
5. Keep on pressing the ”UP” button to lift the vehicle a bit higher from the ground and check again if the vehicle is in a safe position.
6. Having raised the vehicle to the required height, operators must press down the safety lock button to ensure the mechanical safety lock
is engaged. Press the “Emergency Stop ”until the power indicator is off and check again the stability before performing maintenance or
repair work,
Lower the lift
1. Switch on.
2. Press the “DOWN I “button to lower the lift. It will stop lowering when clearance between the platforms and the ground reached to
500mm.
3. Press “DOWN II” button to continue lowering the platforms. Alarming buzz will be heard unless you stop pressing” DOWN II”.
4. Drive the vehicle away
4.5 Emergency lowering in case of no power
Pneumatic lock is not engaged
1. Pull up the safety teeth with steel rope to release the safety lock.
Raising
Lowering
