Once the split pins are removed, replace them with
new ones.
Caution
MAINTENANCE
-34-
REAR WHEEL REMOVAL
1. Remove the rear brake adjuster nut (1) and
disconnect the brake cable from the brake
panel assembly.
2. Remove the split pin (2) and the nut (3).
Disconnect the torque link.
3. Remove the axle nut (4).
4. Pull out the axle (5) and take out the spacer
from the rear wheel assembly.
5. Tilt the vehicle to the left and take out the wheel
assembly along with the brake panel assembly.
6. Reverse the procedure for reassembly.
4
1
3
2
5
STORAGE PROCEDURES
For storage of your vehicle for longer periods of
over a month and above, we recommend to carry
out the following steps:
1. Clean the vehicle thoroughly. Park the vehicle
on center stand.
2. Empty the fuel tank. Turn the fuel cock lever to
‘OFF’ position.
3. Warm up the engine and drain engine cum
transmission oil. Store the oil, if new, in a dust
free container.
4. Run the engine with fuel cock OFF position till
the carburettor fuel bowl becomes empty.
5. Remove the spark plug and feed in several
drops of engine cum transmission oil through
spark plug hole. Crank the engine few times
and reinstall the spark plug.
6. Remove the battery, store it away from direct
sunlight and freezing temperatures.
MAINTENANCE
