78
5. Inspect the fuse for failure. If found defective
Replace the blown fuse with a new (extra fuses
are provided in the wiring harness itself in a
pouch).
6. Close and refit the fuse case back to its position.
7. Turn ‘ON’ the ignition lock and check for proper
functioning of the electrical systems. lncase the
fuse fails again, consult the nearest TVS Motor
Company Authorised Main Dealer / Authorised
Dealer.
Do not use vehicle by shorting the wires without fuse.
This may result in overheating of electrical items / wiring
and may result in fire of vehicle.
Do not use fuse of higher amperage than specified for
the safety of electrical system.
Caution
Good Fuse
Blown Fuse
FUSE
Non-working of electrical systems may be due to
safety fuse failure. Short circuit or overload in the
electrical system are the main causes for fuse failure.
There are two fuse cases containing three blade type
fuses (15A x 1 and 10A x 2) located near the battery.
Follow the procedure given below for inspecting and
replacing the fuse.
1. Turn ‘OFF’ the ignition.
2. Remove the front panel as explained earlier.
3. Take out the fuse case from the battery holder.
4. Open the fuse case and pull out the fuse.
