13
Command
2
Description
R VOLUME
Reports the numerical value for VOLUME setting
S AUDIO DELAY x (x= 0 - 3)
0=OFF
1=40ms
2=110ms
3=150ms
R AUDIO DELAY
Reports the numeric value for the AUDIO DELAY setting (as above)
S AUDIO MUTE x (x= 0 or 1)
0=ON
1=MUTE
R AUDIO MUTE
Reports the numeric value for the AUDIO MUTE setting (as above)
S HDMI AUDIO x (x= 0 or 1)
0=AUTO
1=EXT
R HDMI AUDIO
Reports the numeric value for HDMI AUDIO setting (as above)
S KEY LOCK x (x= 0 or 1)
0=ENABLE
1=DISABLE
R KEY LOCK
Reports the numeric value for KEY LOCK setting (as above)
S FREERUNCOLOR x (x= 0 or 1)
0=BLACK
1=BLUE
R FREERUNCOLOR
Reports the numerical value for the free run color setting (as above)
S RESET 1
Resets the unit to factory defaults
PORT x (x= 0 - 8)
0=LAST MEMORY
1=HDMI 1
2=HDMI 2
3=HDMI 3
4=YPbPr
5=VIDEO
6=PC 1
7=PC 2
8=PC 3
Sets the default
input port at power-on
ST
Checks the FIRMWARE version and SOURCE information:
VERSION: 0.00-x.xx
SOURCE: HDMI - PC3
PORT ON: LAST - PC3
VOL +
VOL -
Raises the volume level (VOLUME IS SET)
Lowers the volume level (VOLUME IS SET)
QUIT
Exit. (Telnet Only)
Notes:
1.
Resolution settings 0-13 are RGB encoded. Resolution settings 14-21 are YUV encoded.
2.
RS-232 commands will be not executed unless followed with a carriage return (CR) command and for some
systems a Line feed (LF) command. Commands are case-insensitive.
5.6
Telnet Control
Before attempting to use the Telnet control, ensure that both the 1T-VS-668 (via the LAN
port) and the PC/Laptop or control system being used are connected to the same active
network.
You may now start your Telnet client of choice and connect directly to the unit’s IP
address. If you wish to use the Telnet software that is built into Windows XP, Vista and 7
please follow these instructions:
1.
Go to the “Start” menu and click on “Run”.
2.
After the “Run” command windows opens type “cmd” then press “Enter”. This will
open the Windows command line interface (CLI).
