6
1. At the remote location, connect the other end of the Cat.5/5E or Cat.6 cable to
the UTP IN connector of the Receiver.
2. Connect the VIDEO OUT connector of the Receiver to the video input of the
remote display or other device, using the appropriate cable.
3. Connect the DC power supplies to the units and then to the AC outlets.
4. Turn on the source device and remote display. The source signal should now
appear on the remotely located display. If not, consult the Troubleshooting
section of this manual.
5.0
OPERATING THE UNITS
Once the connections have been made and power applied, there is little in the way of
operational adjustments required with the possible exception of the Equalization and
Gain adjustments.
5.1
Equalization and Gain Adjustments
On the 1T-CT-422 Receiver, locate the GAIN and EQ (Equalization) adjustments on the
side of the Receiver.
On long cable runs, the high frequency detail can be lost resulting in a “soft” looking
picture. This will first show up in text where the characters will lose their sharp edges.
Adjust the EQ can sharpen the image. While viewing an image on a display connected
to the Receiver, insert a small screwdriver into the EQ adjustment on the side panel of
the Receiver. Rotate gently until the best EQ setting, as determined by image clarity, is
achieved.
Then insert the screwdriver into the GAIN adjustment, and rotate gently until the best
Gain setting, as determined by the brightness of the image is achieved. You may
notice an increase in video noise (sometimes called “snow”) in the picture at higher
gain settings so a compromise will have to be found if the cable run is at or near the
maximum length. EQ and GAIN settings are retained by the Receiver.
6.0 TROUBLESHOOTING
Other than faulty cables or attempting to use the product over too great of distances,
there are seldom problems with these Video Extender products.
Содержание 1T-CT-420 Series
Страница 1: ...Instruction Manual 1T CT 420 Series RGBHV Cat 5 Extender...
Страница 2: ...2...
