TV One 1T-SX-632, Инструкция по эксплуатации

Страница: 8 / 11

6
4.1 Connecting the Inputs to the 1T-SX-632 or 1T-SX-634
You can connect any HDMI compliant device’s output to any of the HDMI inputs. Make
certain that the HDMI cable is securely plugged into the source device as well as the
HDMI Switcher. Always use a high quality cable, as short a length as possible, for best
results.
4.2 Connecting the 1T-SX-632 or 1T-SX-634 Output
Using a high quality HDMI cable, connect the output of the HDMI Switcher to an HDMI
compliant display device. Use the shortest cable run possible.
4.3 Connecting Power to the 1T-SX-632 or 1T-SX-634
Both units are shipped with a Power Adapter to convert 100~240VAC@50-60Hz to
5VDC. Connect the DC Output Cable from the Power Adapter to the back of the unit
and then plug the Power Adapter into an AC Receptacle. You will be able to turn the
HDMI Switchers “On” via either the front panel power switch, the power switch on the
Infrared remote control or via RS-232 commands.
4.4 Using the Positive Cable Securing Feature
If HDMI cables are used that are equipped with Locking type connectors, an added step
is necessary. Remove the Philips head screws from the rear of the unit just above the
HDMI connectors and replace them with the Hex Nut/Screws that came in the 1T-SX-
632 or 1T-SX-634 accessory pack. After screwing these into the threaded holes vacated
by the Philips head screws, the Hex Nut provides a threaded receptacle for the screw
that is part of the locking HDMI connector on the cable. Plug in the cable’s Locking
HDMI connector and secure it to the unit with its integral screw. This fastens the cable
to the unit and prevents its inadvertent removal.
4.5 Optional Rack Mount Kit
The 1T-SX-632 and 1T-SX 634 HDMI Switchers can be mounted in a standard 19”
equipment rack. To mount the units, the optional RM-230 Rack Mount kit must be
purchased. Using this kit, either type HDMI switcher can be mounted in the rack. It is
also possible to mount one of each switcher in the rack using the dual rack mount
capability. It is not necessary to mount two of the same type of switchers.