TV One 1T-DVI-512, Инструкция по эксплуатации

Страница: 7 / 10

5
5.0 OPERATING THE UNIT
Before installation, please make sure all of devices have been turned off.

Connect a DVI-D signal to the input connector using high quality cable

Connect 2 or 4 (depending on model) DVI-D devices to the Distribution
Amplifier’s outputs using high quality cable (*See the Note below)

Plug the 9 VDC power adapter into the rear of the unit

Plug the Power Adapter into a working AC socket

Power on all input and output devices

The DVI input signal should now be available to all devices connected to
the device outputs
* Note: A HDCP compliant monitor or other HDCP compliant device must be
connected to output number 1 for the other outputs of the DA to function properly
with HDCP signals. Once connected, this output cannot be disconnected without
adversely affecting the other outputs. The reason for this requirement has to do
with the copy protection scheme used in HDCP devices and the DDC layer used
to identify the characteristics of the connected devices. Also, because of the
DDC layer, the resolution capability of the device on output number 1 is the
defining factor for the resolution of all other outputs. For this reason, if you intend
to feed monitors or projectors with the DAs outputs and the resolution capability
of the devices vary, make certain you connect a device with resolution capability
compatible with all monitors or projectors to output number 1.
6.0 TROUBLESHOOTING
If the Distribution Amplifier does not appear to be functioning, make certain that
the DVI source and all of the devices connected to the unit are functioning
correctly by connecting each DVI device currently connected to the Amplifier’s
outputs directly to the DVI source using a cable with a length of 6 feet or less. (In
other words, bypass the amplifier to make certain that the problem is not with the
source or destination devices.) If the signal is present under those conditions,
make certain that the power is present to the DA. If it is, measure the cable
length you are attempting to use between the sources to the switcher and the
switcher to the monitor. The input cables should be 6 feet or less in length and
the output cables must be less than 33 feet long and all cables should be
premium quality. Lastly, inspect the cables and connectors for damage.
Note 1: If some devices connected to the DA outputs work but others do not,
make certain that the devices that do not appear to work are HDCP compliant. A
non-HDCP compliant device will not work with a signal that has HDCP encoding
present.
Note 2: If you need to span a distance of greater than 6 feet to reach the DA’s
input, purchase TV One’s 1T-DVI-RH repeater which will allow you to extend a
cable run up to 40 feet using premium cable.