TV Logic LEM-150, Руководство по эксплуатации

Страница: 10 / 52

Multi F
orma
t L
CD M
onit
or
10
Multi F
orma
t L
CD M
onit
or
10
FRONT
Controls, Indicators and Connections
◦
[ANALOG] Button/Lamp
- Used to select the desired Analog input. Press the button to activate the analog input menu-
selection, then use UP and DOWN button to select desired input.
* See section “Other Functions [1]ANALOG Button” for more information (pg 39).
◦
[PBP] Button/Lamp
- Used to select the PBP (Picture-by-Picture) function.
- Selects order of operation: mode 1 -> mode 2 -> mode 3 in sequence.
- Use [SCREEN SEL] (F1,F2,F3 modes) button to select a screen and use SOURCE key (Analog, SDI-A
or SDI-B) to switch the screen to desired input signal.
- The input signal lamp for each of the PBP screens turns on.
◦
[SDI-A] Button/Lamp
- Used to select SDI-A input.
◦
[SDI-B] Button/Lamp
- Used to select SDI-B input.
◦
[F1][F2][F3] Button/Lamp
- Used to activate the function which is set in the OSD Menu “SYSTEM-> F1 MAPPING/F2 MAPPING/
F3 MAPPING” .
- After activation, adjust the function by using UP/DOWN key.
* See section “Menu Contents -> [9]SYSTEM Page” for more information.
◦
[SCAN] Button/Lamp
- Used to change the scan mode. Press the button to activate through the scan modes : OVER SCAN
-> ZERO SCAN -> UNDER SCAN -> 2:1 SCAN -> 1:1 SCAN -> FIT WIDTH -> ZOOM (PBP 16:9 mode)
* See section “Other Functions [2]SCAN Button” for more information (pg 40).
◦
[ASPECT] Button/Lamp
- Used to change the display ratio between 4:3 and 16:9.
- Display ratio locks to 16:9 if the display ratio of input signal is 16:9.
- See section “Other Functions [3] ASPECT Button” for more information (pg43).
MODE1 MODE2 MODE 3