3
Jan 2020
M-1500C-HR
LIFT IS RECOMMENDED FOR INDOOR USE ONLY.
UNPACKING AND SET-UP
1.
Open the crate, then remove items on top of lift.
2.
Carefully remove lift from crate.
3.
Connect hydraulic hose from the cylinder to the air-hydraulic pump.
4.
Connect the compressed air (90-125 psi) supply to the air-hydraulic pump.
5.
Press the
‘Pressure’ pedal side of the air-hydraulic pump to raise up lift.
6.
Mount front wheel vise and then tighten all the bolts and nuts. (Optional)
7.
Mount side extensions with support rods and securing pins.
8.
Mount ramps to rear of lift platform & side extensions
9.
Insert the stabilizer bar to rear of lift
’s base.
10. Lower lift by raising the safety latch bar, until latch is held in upward position.
Followed by pressing the
‘Release’ pedal side of the pump pedal.
11. Without any load, lift and lower the lift several times to remove air from cylinder.
THE LIFT MAY BE DAMAGED AND/OR PERSONAL INJURY MAY RESULT
IF THE PRESSURE EXCEEDS THE MAXIMUM 125 PSI RATING
OPERATION & SAFETY INSTRUCTIONS
LOADS MUST BE CENTERED ON PLATFORM AT ALL TIMES. LOADS
ALSO MUST BE FIRMLY POSITIONED AND SECURED TO PLATFORM AT
ALL TIMES.
1. Only trained persons should operate lift.
2. Center load on platform, not to exceed the 1,500 lbs. maximum weight capacity.
3. Connect to 125 psi maximum shop air to quick disconnect fitting on air-hydraulic
pump.
4. To RAISE, depress the
‘PRESSURE’ end of foot pedal on air-hydraulic pump.
5. To LOWER, lift safety latch bar until held in place magnetically, followed by
depressing the
‘RELEASE’ end of foot pedal to lower.
To STOP lift, position foot pedal to be level. Once the desired working height is
obtained, always lower lift to rest in the locked & secured position.
6. Keep hands and tools from under platform and scissor floor path.
7. Lift must be in the fully lowered position when moving to different locations.
8. The working area should be enough to lift motorcycles & power sport vehicles.
9. Air-hydraulic pump should be positioned at least 2 to 3 feet away from lift during
raising and lowering operation.
Содержание M-1500C-HR
Страница 5: ...5 Jan 2020 M 1500C HR EXPLODED VIEW...
