Tuttnauer LABSCI 15LV, Руководство по эксплуатации и обслуживанию, Страница: 84 / 96

Page 83
•
At the end of the aborted process (before completing the sterilization
stage),
"Cycle Failed" message, error message and a warning
symbol are displayed on the screen. Refer to "Displayed Error
Messages/Symbols".
•
Pressing the START/STOP key cancels the displayed message and
enables opening the door.
If the door is not opened, the vacuum pump will stop automatically
after 30 minutes (ELPV model only).
Warning!
The load has not completed a sterilization cycle, therefore it is
not sterile. Handle it as contaminated load.
10.9 Start Cycle by Clock mode
•
This mode enables the operator to define the time of the beginning of
the cycle. The maximum possible delay is 24 hours. For further
information see
Error! Reference source not found. . Start Cycle by
Clock.
10.10 Moving the Autoclave
1. Disconnect the power supply cord.
2. Disconnect the water and drain hoses.
3. Disconnect the compressed air hoses (if applicable).
4. Drain the water from the chamber.
To avoid injuries, Moving the autoclave should be done by using a
forklift.
Caution:
Before moving the autoclave, verify that the electrical, air and
water connections have been disconnected, and there is no
pressure in the chamber.
Do not drop this device!
10.11 Loading and Unloading the Device
10.11.1 Safety
Protective equipment and clothes and other safety instructions should
be implemented in accordance with local and national regulations
and/or rules!