8
5.
Under
LOUDSP.TYPE
select the type of speakers in the zone. If the zone has one or two 4 ohm or 8 ohm loudspeakers
select
PASSIVE
. If the zone has amplified speakers select
ACTIVE.
Notice: it’s possible to leave ACTIVE with passive
loudspeakers, the only difference is that the maximum output power will be lower.
6.
Enabling
RESTORE STATUS
the zone automatically return to the status it was at unit power off. The option can be
useful whether you want to ensure a continuity of music after lack of electricity
7.
Setting
MAXIMUM VOLUME
it’s possible to limit the maximum listening volume in zone.
8.
If you want to exclude the listening of some sources in a zone within those globally connected (see paragraph 'main
unit settings') you can turn off the check mark next to the names of sources. The same thing applies to the local input of
the zone, named “L LOCAL”
System startup
The startup of the system includes the step of “AFFILIATION” where each zone controller is assigned to the own zone
listening.
1.
Enter the navigation menu (press OK when display is in normal state - time)
2.
Select
UNIT SETUP…
3.
Select
INSTALLATION…
4.
Select
AFFILIATION…
5.
Accept with
YES
the warning message that appears
6.
Perform the procedure to link controllers to zones (refer to controllers’instruction manual). Everytime you can change
the current zone by scrolling the slider over
CURRENT ZONE
line
6.1 for CZ830 controllers push ESC/OFF on every zone’s controllers; to set the next zone push “joystick up” key
6.2 for CZ83 controllers push OFF on every zone’s controllers; to set the next zone push “” key
6.3 for MC1 microphone controllers push UP on every zone’s controllers; to set the next zone push UP again
6.4 for RC83 radio remote controls: push the power off button (in the up-right side of the remote control); to set the next
zone push
near “0” on the numerical keyboard
For others controllers affiliation or further details refer to owners instruction manuals.
7.
When all the controllers have been linked, select
END PROCEDURE
(or press the OK button twice), the unit will
automatically switch off and on
If you want to remotely control audio/video sources through STIF devices or intelligent Tutondo sources (e.g. S2R2UT), you
have to perform a synchronization between zone controllers and that devices.
This operation is required every time
display-zone controllorers devices (CZ830) or STIF (also changes made on IR codes inside STIF) are added to the
system
:
1.
Enter the navigation menu (press OK when display is in normal state - time)
2.
Select
UNIT SETUP…
3.
Select
INSTALLATION…
4.
Select
SYNC. FNC.INTERFACES
5.
Wait until display returns to normal status
The system is now ready to work.