3
3. Hold the plow mount plate up into place again and attach it to the machine with the upper/front U-
clamps and longer M8 x 40mm hex head bolts with a washer on each bolt (see figures 5 & 6). Leave
somewhat loose. An extra pair of hands will make this process much easier.
4. Install the shorter M8 x 30mm hex head bolts with a washer through the rear mounting holes and
thread into the rear rectangular mounting clamps (see figures 7 & 8).
5. Make sure the plow mount plate is aligned with the machine and begin tightening the hardware.
Tighten the hardware gradually together as to allow the clamps to pull the mount plate evenly up to the
machine.
Tusk Limited Lifetime Warranty
Tusk stands behind its products with regards
to manufacturing defects in workmanship and
material. This does not include nor is it limited
to; abuse, neglect, or improper use.
Contact:
Toll Free –
1 (800) 336-5437
