Page | 2
Installation steps:
1.
Start by removing the seat to gain access to the stock seat belt bolts and
mounting. (Some machines may vary)
2.
Remove the stock seat belt and make sure to keep the hardware (may
be re-used).
3.
Use the stock seat belt mount locations to mount the lap belts on both
sides of the seat. Some machines may require additional mounting
brackets (sold separately). When mounting the lap belt, make sure the
angle of the bracket is aimed 40-80 degrees from horizontal to ensure
proper function. The angle of the bracket should be at the same angle as
the lap belt when in use. *Failure to do so may damage the lap belt*.
4.
Wrap the shoulder straps under and back over the harness bar located
behind the seat. The harness bar should be equal to or slightly lower
than shoulder level while the rider is in the seat. Adjust the shoulder
straps to your desired location for the shoulder padding (allow the
sternum strap to be at least 4” below the neckline).
5.
Refer to the image below for the proper way to wrap the shoulder
straps to the harness bar:
INSTA
LLATI
ON INS
TRU
CT
IO
NS
A
N
D INFOR
MA
TIO
N
INSTA
LLATI
ON INS
TRU
CT
IO
NS A
N
D INFOR
MA
TIO
N
Tusk 5 Point SFI Approved Safety Harness
