Tusa Element II, Руководство пользователя

Страница: 103 / 116

103
• If it is necessary to clean the Battery Compartment, flush it
and all components with a solution of 50% white vinegar
and 50% fresh water. Rinse with fresh water, and allow to
dry overnight, or blow dry with a hair dryer set at no heat.
WARNING: If damage or corrosion is found,
return your Element II to an Authorized TUSA
Dealer, and DO NOT attempt to use it until it has
received factory prescribed service.
Battery Installation
• Slide a new 3 volt type CR2450 Lithium Battery, negative
( - ) side down into the Battery Cavity. Slide it in from the
right side and ensure that it slides under the contact clip on
the left rim of the cavity (Fig. 103).
• Orient the Retaining Bar across the lower portion of the
Battery and carefully push it down into position (Fig. 104).
Battery Hatch and Hatch Retaining Ring Installation
• Replace the Hatch O-ring with a new one which must be a
genuine TUSA part.
• Lightly lubricate the new Hatch O-ring with silicone grease
and place it on the inner rim of the Battery Hatch (Fig.
105). Ensure that it is evenly seated.
• Slide the Hatch Retaining Ring, top portion first (small
opening), onto your thumb.
Fig. 103 -INSERTING
BATTERY
Fig. 104 - INSERTING
RETAINING BAR
Fig. 105 - O-RING ON RIM
OF HATCH