·
13
DEC INC
DEC INC
INC
DEC
DEC INC
DEC INC
DEC INC
INC
DEC
The battery is on the cyclic process of charge and discharge can
often become warm after charge or discharge period. The
program can insert a time delay to occur after each charge and
discharge process to allow the battery adequate time to cool
down before being subjected to the next process. The value
ranges from 1 to 60 minutes.
You can set the trickle charge mode on or off. If it is on, the
charger will automatically supply the trickle charge current to
achieve the full charge without overheating the battery after fast
charge has been terminated.
DEC INC
INC
DEC
INC
DEC
DEC INC
DEC INC
DEC INC
DEC INC
DEC INC
INC
DEC
DEC INC
INC
DEC
This program sets the maximum charge capacity that will be
supplied to the battery during charge. If the delta-peak voltage is
not detected nor the safety timer expired by any reason, this
feature will automatically stop the process at the selected
capacity value.
This program monitors the voltage of input battery. If the voltage
drops below the value you set the operation forcibly terminated to
protect the input battery.
When you start a charge process, the integral safety timer
automatically starts running at the same time. This is
programmed to prevent overcharge the battery if it proves to be
faulty, or if the termination circuit cannot detect the battery full.
The value for the safety timer should be generous enough to
allow a full charge of the battery.
The beep sounds at every time pressing the buttons to confirm
your action. The beep or melody sounded at various times during
operation to alert different mode changes. These audible sounds
can be turned on or off.
You can adjust the brightness of LCD screen at the charger.
An optional feature using temperature probe contacting the
surface of battery, the temperature cut-off can be on or off. If it is
on, set the maximum temperature at which the charger should
allow battery to reach during charge. Once a battery reaches this
temperature during charge, the process will be terminated to
protect the battery.
INITIAL PARAMETER SETUP (USERS SET UP)
