Standard Slipper Assembly Page 19/23
Solder the Servo wires to the Malenki:
* Note *
it’s helpful to have the Malenki on the Blu
-Tak.
38. The servo
Ground Wire
(
Brown
in these photos)
solders to the joint of the Black Wire from the JST
Battery connector though the PWR
–
through-hole.
39. The servo
Power Wire
(generally
Red
) similarly
solders to the joint of the
Cut Red Wire
from the
switch through the PWR+ through-hole. It can be
helpful to use needle nose to hold these wires close
to the end to get a secure joint.
40. The servo
Signal Wire
(
Orange
in these photos) is
soldered to the WEAPON2 pad (closest to the
through holes / bottom of the Malenki).
34
38.
39.
40.
Содержание SLIPPER
Страница 1: ...1 ...
