7
Figure 14
Figure 15
9. INSTALLING THE LIGHT
KIT
REMEMBER:
To disconnect the power. The fan
blades must be already attached to the fan.
Your fan and light kit though pre-wired have been
disassembled at the factory to ease in shipping.
Please follow these steps to complete the
installation of your fan and light. TO REDUCE THE
RISK OF FIRE DO NOT EXCEED MAXIMUM
WATTAGE RATING.
Step 1. Remove the 1 of 3 screws from the
mounting ring and keep it for future use. Loosen the
other 2 screws (Do not remove)
Step 2. Raise and hold the light kit close to the
mounting ring and proceed to do the wire
connections. Connect the white wire connectors
from the light kit and fan, follow the same procedure
with the black wire connectors. (Fig. 14)
Step 3. Place the light plate key holes over the 2
screws previously loosened from the mounting ring,
turn light kit until it locks in place at the narrow
section of the key holes. secure by tightening the 2
screws previously loosened and the one previously
removed. (Fig. 14).
Step 4. Install 3 x 40W candelabra bulbs (included).
(Fig. 15)
Step 5. Raise the glass shade up against the light
plate and secure it to the fan with the light kit stem.
DO NOT OVERTIGHTEN. (Fig. 15)
Mounting ring
Light kit
Screws
Connection plugs
Light kit stem
Light kit
Glass shade
Bulbs
