B1406 9
www.turck.com • Phone: 763-553-7300 • Application Support: 1-800-544-7769 • Fax: 763-553-0708 • Turck Minneapolis, MN 55441
www.turck.com • Phone: 763-553-7300 • Application Support: 1-800-544-7769 • Fax: 763-553-0708 • Turck Minneapolis, MN 55441
Figure 2-2: Mounting EZ-track in a Hydraulic Cylinder
Figure 2-3: Port Detail (SAE J1926/1)
A
.004 A
.008 A
125
125
PITCH
DIA.
REF.
SEE NOTE 4
.094 MAX.
R.015
MAX.
.008
.004
R
RECOMMENDED
MIN. SPOTFACE
DIAMETER
SEE NOTE 1
1.18
.500
.866
.813
+/-.002
45°
15°
.106
+/-.008
1.250
SEE NOTE 3
SEE NOTE 4
3/4-16 UNF-2B THREAD
1.100
SEE NOTE 4
MINIMUM
SEE NOTE 2
NOTES:
1. If f ace of po
rt is on a
machined sur
f ace,
dimensions 1.180 and .094
need no t app l y as long
as R.008/.0004 is
main t ained t o avoid
damage t o the O-ring
during assemb l y.
2. Measure perpendicu
-
larit y t o A at this
diameter.
3. This dimension
applies
when t ap dril l canno t
pass through entire
boss.
4. This dimension does
no t conform
t o SAE
J1926-1.
1. O-ring
2. Optional rod bushing
3. Standard 4-hole magnet
4. Magnet spacer
5. 0.5" bore minimum
Notes:
1. If face of port is on a machined surface, dimen-
sions 1.180 and .094 need not apply as long as
R.008/.0004 is maintained to avoid damage to
the o-ring during assembly.
2. Measure perpendicularity to A at this diameter.
3. This dimension applies when tap drill cannot
pass through entire boss.
4. This dimension does not conform to SAE J1926-1.