turck EZ-track, Руководство пользователя

Страница: 11 / 20

B1403 11
www.turck.com • Phone: 763-553-7300 • Application Support: 1-800-544-7769 • Fax: 763-553-0708 • Turck Minneapolis, MN 55441 www.turck.com • Phone: 763-553-7300 • Application Support: 1-800-544-7769 • Fax: 763-553-0708 • Turck Minneapolis, MN 55441
3 .5 Features
Automatic Gain Control
The Automatic Gain Control feature will automatically search and find the magnet on power up, if power is applied without
a magnet on the LDT, the LED will turn RED indicating no magnet signal is detected . Turn power off and place magnet within
the active stroke area . Re-apply power .
When using the Floating Magnet assembly, the magnet should be installed within 3/8” of the sensing surface . The magnet
assembly should also be installed so that it remains an even distance from the aluminum extrusion throughout the entire
stroke . Improperly installed magnets can result in output signal non-linearity .
Burst Mode
This feature enables the system to be absolute even though data transfer is through an incremental method . In the event of
power failure, the controller can be programmed to automatically send a signal to the probe, which will then respond with
the current position data . An input signal to the probe will cause a “Burst” of data, representing the absolute position, to be
fed back to the controller .
LED Colors
Green
Magnet is present and within the active programmed range .
Red
Fault, the LDT has lost its signal from the magnet or the magnet has moved inot the Null
or Dead zone .
Yellow Factory use only . Used to determine when the LDT is in the programming mode .