Turbosaver TS-1100, Руководство пользователя

Страница: 19 / 22

19
1. Wash the bags with warm water with a mild dish soap.
2. When washing the bags in the dishwasher, rotate them and spread them over the top
rack of the dishwasher, so that the entire surface is exposed to the wash water.
3. Dry well before reuse.
IMPORTANT: To avoid possible diseases, do not reuse the bags after storing raw meats,
raw fish or fatty foods. Do not reuse bags that have been heated or boiled.
Storage of your vacuum sealer:
1. Keep the unit in a safe and flat place, out of the reach of children.
2. Install the power cord into the cable storage before storing this appliance. Do not wrap
the cable around the machine.
PROBLEM SOLVING
Nothing happens when I try to vacuum pack.
1. Check the power cord to see if it is firmly plugged into the outlet.
2. Examine the power cord for damage.
3. Check if the outlet is operative by plugging in another device.
4. If your device has a mode switch, make sure it is set to the correct mode. See the pre-
vious operating instructions.
5. Make sure the bag is correctly positioned inside the vacuum chamber and below the
air inlet.
6. Make sure that the safety switch is operated by pressing the cover down hard.
The air is not completely removed from the bag:
1. Make sure that the open end of the bag rests completely within the area of the vacuum
chamber.
2. Check the sealing strip, the surface of the heating element and the foam gasket under
the cover for debris and position. Make sure there is no breakage or distortion of the foam
sealing gaskets on the cover and the base around the vacuum chamber. Clean and replace
them in place.
3. The vacuum bag may have a leak. To test, seal the bag with some air, submerge it in
water and apply pressure. The bubbles indicate a leak. Reseal or use another bag.
4. Use only the specific vacuum bag with vacuum channels provided by the manufacturer.
5. Leaks along the seal that may be caused by wrinkles, crumb residues, grease or liquids.
Reopen the bag, clean the inside top of the bag and smooth it along the sealing strip
before resealing.
The vacuum packaging system # 1