turbofan E931M, Инструкция по установке и эксплуатации, Страница: 7 / 18

Installation
5
Cooktop:
NOTE: All electrical connections must only be carried
out by a suitably qualified person.
To access the electrical connection terminal block, remove
the back panel.
When connecting the Cooktop to the mains supply, ensure
that the following is carried out:-

Arrange for a supply cord which should be oil-resistant,
sheathed flexible cable and not lighter than ordinary polychlo-
roprene or other equivalent synthetic elastomer sheathed cord
(as per AS/NZS 3191 part 2.10.11. or IEC 60245-IEC-57) e.g.
HO5 RN-F Type.

An isolating switch is fitted within 2 m of the appliance, but
not on the appliance and in such a position that the user does
not have to reach across the cooking surface.

The branch supply line shall be individually overload protected
to the correct current rating and the supply chord shall be
protected against any mechanical or thermal damage.

A grommet is fitted around wiring entry hole into appliance.

All wiring connections must be tight.
Refer to appropriate wiring standards for size of cable that is to
be supplied to an appliance for the current drawn on that line.
Single Phase Connection (Standard Ex-Factory);
NOTE: For 3 Phase Connection option, refer to the
Electrical Schematic section in this manual.
Positioning and Levelling of Range
1. Correctly locate the range into its final operating
position and using a spirit level, adjust the range feet
so that the range is level and at the correct height.
Initial Start-Up
Before using the new range;
1. For first time use of the range, it is essential that the
following operation is carried out to remove any fumes
or odours which may be present:-

Turn ‘On’ the hob elements to ‘HI’ for 3 minutes.

Turn on the oven to 200°C / 400°F for about 1
hour.
NOTE: Some smoke may be seen exiting from the
vents between the top of the oven and the
underside of the Hobs, this is normal on initial
start up and will soon disappear as the oil on
the new steel is heated and evaporates off.
2. With continued use the ‘Red Spot’ in the centre of the
elements and the stainless steel trim ring around the
outside of the elements may discolour. This is a natural
result of heat and does not affect the operation of the
element.
3. Please refer to the Operation Section of this manual for
details on how to correctly operate and shutdown the
range.
Commissioning
Before leaving the new installation;
Check the range functions in accordance with the
operating instructions specified in the ‘Operation’
section of this manual.
Ensure that the operator has been instructed in the areas
of correct operation and shutdown procedure for the
appliance.
NOTE: If for some reason it is not possible to get the
appliance to operate correctly, turn off the
power supply at the mains supply and contact
the supplier of this appliance.
For Cooktop wiring, connect
Single Phase connection to
L1, N and Ground (Earth).
The Oven power supply will
come already wired up with
cordset and plug attached.