turbofan E32D5, Инструкция по установке и эксплуатации, Страница: 26 / 27

Appendix 1 - Oven Door Reversal
24
18. Remove Blanking Screw and Door Catch from front of oven
and swap around (refer ‘Adjusting Door Catch’).
19. Fit door spacers removed at Item 13 on previous page, to
lower hinge pivot bolt.
Oven Door Re-Fitting
Fit the Door.
1. Refit oven door by locating
bottom of door onto bottom
hinge plate pivot bolt and
spacers.
2. Fit top of door into top hinge
plate and secure with top pivot
bolt.
Fit Inner Glass to Door.
NOTE: It is important to ensure that the inner glass is fitted
correctly and that the glass pivots at the hinge end
of the door and not the handle end.
1. Fit pivot spacer removed at Item 3 on previous page, to the
lower inner glass pivot and locate inner glass lower pivot into
position on inside of door.
2. Locate top pivot of inner glass into
top of door and secure in position
with inner glass retaining clip.
3. Lift inner glass up onto locking
catch to lock glass into position.
Top Door Pivot Bolt.
Inner Glass Locking Catch
Screw and
Retaining Clip.
Adjust Door for Correct Alignment.
Check alignment and operation of the door. Ensure that the door
is correctly aligned horizontally and vertically.
1. To align, slacken off the upper and
lower hinge plates and correctly
align the door. Re-tighten both
hinge plates.
2. Check that the roller catch correct-
ly retains door in the closed
position.
3. To adjust, slightly loosen screws
securing roller catch and close the
door. The roller catch will
centralise itself.
4. Open door and tighten roller catch
securing screws.
Adjusting Door Catch
If the door sealing requires adjustment, carry out the following to
adjust the door catch:-
1. Check that the door seals correctly when closed, by placing a
sheet of paper between the door and the seal.
2. Close the door on the paper and attempt to withdraw the
paper by firmly tugging on the paper. The paper should just
pull out with some resistance but without tearing.
3. To adjust the door catch, loosen the locking nut on the door
catch:-
a. If the paper withdraws easily,
screw the door catch ‘In’
by ½ a turn
and repeat the
test above until adjusted
correctly.
b. If the paper cannot be
withdrawn and the door
springs open,
screw the door
catch ‘Out’ by ½ a turn
and
repeat the test above until adjusted correctly.
4. Tighten the locking nut on the door catch.
Slacken these screws to adjust
door vertically - horizontally.
Door Catch
Locking Nut
Blanking Screw