7
Getting Started
IMPORTANT –
Please Read and Follow!
Service
•
Should this appliance require service,
please call Viking Range, LLC at
1-888-(845-4641). A qualifi ed service
representative will assist you and if
required, coordinate a service visit by an
authorized service agent in your area.
Power Connections
•
To avoid potential hazards, only the
manufacturer, its service agent, or a
similarly-qualifi ed person should replace a
damaged power cable. Flexible conduit,
conductors and connectors are supplied
by the manufacturer. The oven must be
connected using the fl exible conduit and
conductors provided.
Self-Cleaning Oven Guidelines
•
Clean the oven only in accordance with
the guidelines provided on page 49.
•
Before self-cleaning the oven, remove
broiler pan, grid, racks, and other
cookware. Clean only parts listed in
manual.
•
Listen for fan—a fan noise should be heard
during the self-cleaning cycle. If not, call
Viking Range, LLC at 1-888-(845-4641)
before self-cleaning again.
•
DO NOT
clean the door gasket. The door
gasket is essential for a good seal.
DO NOT
to rub, damage, or move the
gasket.
•
DO NOT
use oven cleaners. No
commercial cleaner or oven liner
protective coating of any kind should be
used in or around any part of the oven.
Residue from oven cleaners will damage
the inside of the oven when the self-clean
mode is used.
•
In the event the oven is malfunctioning in
the self-clean mode, turn the oven off or
disconnect it from the power supply and
call Viking Range, LLC at 1-888-(845-4641).
•
Complete instructions on the operation
of the self-clean mode can be found on
page 49.
RF Interference Considerations
•
The appliance has been tested and
was determined to be in compliance
with applicable portions of FCC part 18
requirements and with the protection
requirements of Council Directive 89/336/
EEC on the approximation of the laws
of the European Union Member States
relating to electromagnetic compatibility
at the time of manufacture. However,
some equipment with sensitivity to
signals below these limits may experience
interference.
•
If any equipment experiences interference,
the following steps should be considered:
o
Increase the physical distance between
the sensitive equipment and this oven.
o
If the sensitive device can be grounded,
do so following accepted grounding
practices.
o
If battery-powered microphones are
being affected, ensure that the batteries
are fully charged.
o
Keep sensitive equipment on separate
electrical circuits if possible.
o
DO NOT
route intercom wires,
microphone wires, or speaker cables
near the oven.
SAVE THESE INSTRUCTIONS
