turbionaire 5949096154288, Инструкция по эксплуатации

Страница: 12 / 42

DRAINAGE
There are two ways of removal collected water produced by the unit.
a) Manual draining: Empty water tank by manual.
b) Continuous draining: Use gravity to drain condensate water by attaching a drain hose.
EMPTYING THE WATER TANK
The water tank built in unit will fill up and shut the unit down once it is full. It will run again once
you empty the water tank and installed properly.
1) When the tank is full, the “FULL” light will turn on.
2) The unit will make a buzzing sound. Press the power button to turn off the machine.
3) To empty the water tank, open the front panel to access the water tank.
4) Grab the handle of the water tank and pull it out horizontally.
5) After disposing of the water, replace the tank and close the front panel.
6) Press the POWER button to resume operation.
CONTINUOUS DRAINING
For continuous operation or unattended dehumidification, please connect the attached drain
hose to the unit. Press the POWER button to turn off the machine. Open the front lower cover;
remove the water tank from the unit.
Push the drain hose through the continuous drainage opening and connect one end to the hose
connection. Refit the water tank in the unit and close the front lower cover. Direct the other hose
end to the desired area. Make sure the drain hose is not kinked or bends.
Remove the hose and seal the hose connection off with the plug if you want to collect the water
in the water tank again. Allow the hose to dry prior to storage.
WARNING:
Do not block the drain hose, water will
not drain properly and could damage
components of the unit.
12