Tunze 7096, Инструкция по эксплуатации

Страница: 81 / 157

81
„Interval“ - low and high tide simulation
The interval operation alternating between low tide (pump outputs 1 / 2) and high tide (pump outputs 3 / 4)
permits two-way circular currents in the aquarium. The reef rocks are flooded from both sides in regular
intervals causing the sediment to be washed away, and the invertebrates are perfused from all directions.
We recommend that the same pumping capacity is set for both channels, if possible.
Click the “Interval” button in the “Mode” field.
Click the “Interval time” field to set a time between 1 minute and 12 hours; six hours would be ideal, like in
nature.
Click „Power 1“ and „Power 2“ pump outputs in the „Power control“ field to set channels 1 to 4. Figure
“0” indicates that the pump is not operational. The smallest possible setting is 30 per cent which can be
increased to 100 per cent.
Set the “Pulse flow” pulse frequency from 0.30 to 8.00 seconds. This pulse frequency is precise and can
also be used as Wavecontroller. Wave simulation on a pump output can also be switched off by identical
setting of “Power 1” and “Power 2”. Both values are set to 60 per cent, for example; the pump on this port
has a continuous output and pulse operation is deactivated.
Up to four pumps can be connected directly. By using two branch adapters 7092.34, an extension to a
maximum of eight pumps is possible.
The following function can be activated in the “min. flow for switched off pumps” field:
The circulation pumps are not switched on and off alternately, but the pumps are set variably between a
selectable output and the minimum output (30 per cent).